Setting up OlympusNet DSL

This document contains general setup information that can be used by all OlympusNet DSL customers. Start by filling out your ISP worksheet with the information given below, then continue with the instructions for configuring the Actiontec. The exact setup procedure you should follow is determined by the type of modem you have and the number of computers you will be connecting to DSL.

Fill out your ISP Information Worksheet

Included with your Qwest DSL kit should be a sheet of heavy paper titled "Read Me Second". On the back of this is your ISP Information Worksheet. You may fill it out as follows:

Name of your ISP	OlympusNet
Technical Support Phone Numbers	360-385-0464 or 1-800-896-1751
Protocol	Bridged (RFC1483)
IP Address Setting	Static IP
PPP Login Name & Password	Not used

Static IP Address	This will be supplied to you by OlympusNet
Subnet Mask	255.255.255.0
Default Gateway (or Router Address)	This will be supplied to you by OlympusNet
Primary DNS	65.117.224.77
Secondary DNS	198.133.237.1
Host Name	olympus.net
WINS address	Not used

The Actiontec DSL modem can support multiple computer connections. However, the current Actiontec GT 701 DSL Gateway provided by Qwest has only one Ethernet port and only one USB port for one computer. OlympusNet will assist you with an Ethernet cable connection for one computer. OlympusNet does not provide tech support for networking, wireless connectivity, or connections using a USB cable. As a courtesy to our customers, a guide for turning on the wireless feature in the Actiontec is provided here. If you will be setting up more than one computer to share the DSL connection, or if you want to set up a wireless connection, you may need to contact a Networking Consultant for help with the network setup. You may also contact Actiontec's technical support for help with a wireless connection at (888) 436-0657.

Follow the instructions in Qwest's Quick Start Guide and use the following guidelines for configuring the DSL modem:

Updated 2008-09-29